Emocean Knowledge

How boats really work.

Rigging, propellers, trim and fuel — explained plainly, as best practice. For every owner, whoever built the boat.

Understanding pitch

A propeller is described by two numbers — diameter × pitch. Most owners know the first. The second decides how the boat feels.

What pitch measures

Pitch is the distance, in inches, a propeller would move forward in one revolution if it were turning through something solid. A 21-inch-pitch propeller would travel 21 inches per turn. Think of it as gearing: more pitch is a taller gear — more speed at the top, less punch out of the hole.

Slip, and why it matters

Water is not solid, so a propeller never covers its full theoretical distance. The shortfall is slip. A well-matched propeller on a planing hull typically runs at around 10–15% slip; much more suggests the wrong propeller, ventilation, or an engine mounted at the wrong height.

Rule of thumb

Each inch of pitch moves wide-open-throttle rpm by roughly 150–200. Add pitch and rpm drops; remove pitch and it rises.

Reading wide-open throttle

Every outboard has a manufacturer-specified full-throttle rpm range. With a typical load aboard, the engine should reach the upper half of that range. Below it, the engine is over-propped and labouring; above it, the rev limiter is doing work the propeller should be doing. Test with the load you actually carry — fuel, water and guests.

Cup, rake and bow lift

Cup — a small curl at the blade’s trailing edge — holds water, reduces ventilation and adds a little bow lift. Rake, the angle the blades sweep back, lifts the bow further and lets the engine be trimmed out and run higher. Both trade some low-speed grip for top-end efficiency.

More in Knowledge

Propellers

Choosing the right propeller

Aluminium or stainless, three blades or four — what each changes on the water.

In preparation

Rigging

Engine height, done properly

How mounting height and setback decide speed, grip and fuel burn.

In preparation

Trim

Stern lift and bow lift

How trim, tabs and propellers balance a hull — and why porpoising happens.

In preparation

Fuel

When petrol goes bad

Heat, time and moisture: how fuel degrades and how to prevent it.

In preparation

Hulls

Deep-V, stepped or twin hull?

What each hull form does well, and what it asks of you in return.

In preparation